gold-seal.GIF (17839 bytes)


buildcom-title2b.GIF (15258 bytes)
line.GIF (550 bytes)

PROJECT APPENDIX A - 8

PRE-ASSEMBLED & PORTABLE BUILDINGS

SUMMARY OF ABC REQUIREMENTS & PROCEDURES
line.GIF (550 bytes)

  •  ALL PRE-ASSEMBLED AND PORTABLE CLASSROOM BUILDINGS LOCATED ON STATE PROPERTY OR USED BY ANY GOVERNMENTAL BOARD, COMMISSION, AGENCY, BODY, AUTHORITY, INSTRUMENTALITY, DEPARTMENT, OR SUBDIVISION OF THE STATE SHALL:

                       A. BE INSTALLED BY A CERTIFIED INSTALLER;

                       B. POSSESS A MANUFACTURED HOUSING COMMISSION 

                           LABEL.

  •  THE SUBMISSION OF A SITE PLAN AND OTHER APPLICABLE DRAWINGS AND SPECIFICATIONS SHALL BE FORWARDED TO THE TECHNICAL STAFF FOR PLAN REVIEW WHEN LOCATING OR RELOCATING THESE STRUCTURES. USE ABC FORM B-1: TRANSMITTAL OF PLANS AND/OR SPECIFICATIONS, WHEN SUBMITTING DOCUMENTS FOR REVIEW. THESE DRAWINGS SHALL (AT A MINIMUM) DELINEATE THE FOLLOWING:

                    A. LOCATIONS AND DISTANCES BETWEEN UNITS AND

                        ADJACENT STRUCTURES.

                    B. UTILITY (WATER, SEWER, POWER, ETC.)

                        CONNECTION/SERVICE.

                   C. ACCESSIBILITY PROVISIONS (ADAAG) TO THE

                       STRUCTURES (RAMPS, WALKS, HANDRAILS, ETC.).

                   D. ADEQUATE RESTROOM FACILITIES.

NOTE:

ONLY ONE (1) PLAN SUBMITTAL IS REQUIRED FOR THESE PROJECTS.